Patrick metalwork lathe. Two chucks. Bench not included but it is mounted on its own table top. What you see is what u get. Oil pots on main shaft with wick oilers work well. I dont know much about lathes. It was my fathers. Runs fine... About 40kgs.

photo 2 shows .spare 3 jaw chuck as well as the reversible 3 jaw in it. 350mm between chuck and end thing. Chuck has hole in the centre so work can pass through. Multi speed by changing belt pulleys.I know little about lathes sorry. Standard house 3 pin plug. Start stop switch. One cutting tool. Chuck key.. Total length about 1300mm. Been told oil pots better than bearings as main shaft is thicker. Oil pots work well. Perfect for small to medium builds. Pick up pakuranga.