It used 9.5 inches special tiny design. Two Channels Model 120W RMS/Per channel. Stereo into 4-8 Ohm loads. Bridged mode 240W output for 70V or 100V (Direct Drive) Power down after ~15 minutes of no signal and comply with Energy Star Power consumption limits of < 0.5W in standby. Red LED ( Front Panel) to indicated Standby mode is active. Terminal Block analog audio inputs. Selection for Power-Up mode. Switch for High Pass Filter. Natural cooling without Fan. TRIGGER could be external remoting ON/OFF. Short circuit protection. Overheating protection. Specifications Stereo Mode (all channels driven) 120W x 2, 8O (31 V) RMS output (steady state), per channel @ < 1 % THD+N 120W x 2, 4O (22 V) RMS output (steady state), per channel @ < 1 % THD+N Bridged Outputs For 70V/100V (Switch at HIZ position) 240W, 70V @ < 1 % THD+N 240W, 100V @ < 1 % THD+N Frequency Response 20 Hz - 20 kHz, +/- 2 dB @ 4O Load Signal to Noise >90dB @ 1W(20 Hz - 20 kHz) Input Sensitivity 1.0V (+0dBu) @ Max Output 4O Gain Value ? 25 dB @ 4O Input Impedance >10k, Balanced. Maximum Input Level 12.3 V (+24 dBu) Trigger In/Out DC 12V High Pass Filter 80 Hz(2dB) Input Connector 5 pin Euro terminal Trigger Connectors 3.5 mm Jacks Output Connectors 4 pin Euro terminal (4O/8O) Dimensions 214mm(W) x 249.8mm(D) x 44mm(H) Net Weight 1.94 Kg Power Requirements 100 - 240 VAC, 50 - 60 Hz, 350W

Happy Trading! Thanks for Visiting Bourne Electronics