ANTHEM M1 Mono Block Amplifiers ( set of 2) EX-DEMO: As New Condition.

State-of-the-Art Monaural Amplifier The highest sound quality at all volume levels unthought of, Flat frequency response into any load, and stable into the most difficult loads. The Statement M1 is a state-of-the-art monaural amplifier delivering 1,000 watts into 8 ohms and 2,000 watts into 4 ohms or less with THD remaining under 0.1% from 20 Hz to 20 kHz.

More than just a slim, technologically advanced monaural design, the M1 demonstrates that Class D architecture isn't fundamentally flawed, it simply hasn't been implemented well in the past, mainly because it required such a heavy commitment to R&D. We’re fortunate to have the in-house resources to create such a groundbreaking product and one listen will reveal the truly extraordinary nature of this amplifier.

Cutting Edge Technology & Design Full resolution of all of the sonic subtleties and complexities in the input signal. Accurate reproduction of the full dynamic range of the signal. The output stage is never allowed to clip. No compression as output increases. Flat frequency response into any load, without having to resort to digital conversion or equalization to compensate. Stable into all loads including open circuit and short circuit. A low noise floor. Exceptional efficiency with low heat output. An amp so mechanically silent it will suit even the quietest listening room. A design that allows multiple units to be stacked with no danger of overheating. All of the above delivered at a price point that while not inexpensive, delivers virtually limitless dynamic fidelity. Recommended Sell = $15,999 Set of 2

Trade Me offer = $3999 for a set of 2.

Save $12,000

This most Horsepower any Hi-Fi Enthusiast could ever dream for Should you be an Apogee or DynAuio owner or a similarly difficult drive High-End Speaker brand here is a Special Product to consider

MADE IN CANADA :