This listing is for a prewired set of PH type (aka PH-2.0, JST-PH) through hole wire-to-board connectors, YOU MUST CHOOSE 2, 3, 4 or 5 pole, if you don't tell me, I can't send it!

PLEASE NOTE! Check your polarities, don't just assume "oh, red, that must be X volts, oh black that must be ground", I don't know what voltages or signals your device puts or expects on each wire and neither does the Chinese factory that made these wires. Check twice, don't burn your house down.

PH connectors have a 2.0mm pin pitch and can carry about 2A Maximum. They are commonly used for power from batteries (2p) and balancing connectors (3p+) of course you can also use them for data, or servos or motors or potentiometers or anything.... that's kinda how connectors work, they connect things, who knew.

Each "item" you buy gets you a pack (you choose, 2, 3, 4 or 5 pole) containing:

1 of PCB mount pin header (vertical through hole) 1 of plug with wires already attached

Measured from the back of the plug (so not including plug);

The 2 Pole connectors have a wire length approx 11cm The 3 Pole connectors have a wire length approx 9cm The 4 Pole connectors have a wire length approx 11cm The 5 Pole connectors have a wire length approx 19cm

It's a lot easier than crimping your own PH connectors that's for sure.

But if you did want to crimp your own, check out my other listings for just the connectors and pins!

Check my other listings for different PH socket types available... http://tinyurl.com/y4yrftoy

I have a variety of PCB headers available, see my other PCB Header listings here: http://tinyurl.com/y9qxvb3h

See all my stuff - https://tinyurl.com/y8b8t6y2 - pay shipping on one item and choose combine for the rest!