Radiator Coolant Vacuum Purge & Refill Kit Cooling System Tester Tool Kit

Radiator Coolant Vacuum Purging & Refill Kit

This set is designed to refill radiator coolant by creating a vacuum in the cooling system, allowing coolant to be replaced without introducing air pockets. Supplied with a cone shaped adaptor to suit a variety of radiator filler necks. There is no need to undergo checking the air bleeding after refilling the new coolant.

Kit contains: 1x Vacuum Purge & Refill Tool with Gauge 1x Cone Adapter 2x Hose 2x Air Fitting 1x Storage case

These are a must for any workshop !

Instructions:

Step 1: Drain coolant from vehicle and flush if necessary.

Step 2: Mount gauge assembly under bonnet using chain and hook.

Step 3: Select correct cooling system adaptor and connect to cooling system ensuring a complete seal.

Step 4: Ensure all taps and switches are in the off position. Connect the thin clear PVC drain tube to the gauge assembly directing overflow to bucket.

Step 5: Connect airline to air inlet male airline brass fitting. Ensure tap is open then push on/off switch to the open position.

Step 6: Once required vacuum is achieved turn tap to the off position and close the on/off switch.

Step 7: Connect the coolant large clear hose to the assembly quick release fitting and insert into the replacement new coolant.

Step 8: Turn tap to the on position to allow replacement coolant to be drawn into the cooling system. When gauge reading reaches zero disconnect assembly from the cooling system. Check coolant level and top up if required.

Elite Retail is 100% New Zealand owned and operated. All our stock is located in Auckland to ensure super fast shipping!

Shipping: Your order will usually be shipped out within 24 hours of it being placed Monday-Thursday. For more information on this as well as information on our Combined Shipping feature, please see our Shipping and FAQ page on our Store help section.

PO Box addresses are welcome!

GST Receipts are available upon request!