CNC MOSFET Regulator Assorted Models (Refer to Fitments) (RMS022-105928)

Description

RMSTATOR Red Machined Aluminum Mosfet Regulator Our new RMSTATOR machined aluminium Mosfet voltage regulator is a great upgrade for heat dissipation in any Powersports charging system. After 10 minutes of use, our billet aluminium heatsink runs cooler by 33% than standard cast regulator housings. Our new RMSTATOR red regulator, equipped with the renowned Mosfet regulation technology, is an added value to any three-phase permanent magnet charging system. STOP BURNING YOUR REGULATOR RECTIFIER! It is time to update or replace your voltage regulator with the advanced MOSFET type. It runs cooler than all OEM diode style regulators. In addition, this rectifier has overheat protection, rather than burn up, it will simply turn off for a while and cool off.

Direct replacement to your original unit
Plug-and-play, direct fit, easy installation
The quality exceeds the OEM equipment
Improved heat sink and charging capabilities
Higher grade of electric components
All shipped products are tested We have even included the opposite connector (main harness side) as we know these are often melted/corroded/defective and a major cause of repetitive electrical issues. What are the advantages of the MOSFET Technology?
Runs much cooler than the traditional Shunt voltage regulator rectifier
Less load on the stator, less work, less fuel is used and you save
The power charging your battery is steadier and smooth
Extends the battery's life and cold-cranking capacity
Removes stator load resulting in more engine power
Optimize power delivery by switching the stator coils on or off NOTE: Battery condition is extremely important. No voltage regulator can work correctly with a bad or weak battery. Always fully charge your battery before performing any charging system tests or replacing parts. If there is any doubt, have the battery load tested or replaced. Please Note:
All electrical components must be fitted by a qualified technician.
Before fitting elec...